Sharp R-308N ユーザーズマニュアル

ページ / 21
5
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug. 
It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National 
Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk 
of electric shock by providing an escape wire for the electric current.
WARNING
 – Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more 
protected electrical supply. It is recommended that a separate circuit serving   
only this appliance be provided. 
The oven is equipped with a 3-prong grounding plug. It must be plugged into a 
wall receptacle that is properly installed and grounded. Should you only have a 
2-prong outlet, have a qualifi ed electrician install a correct wall receptacle.
A 3-prong adapter may be purchased and used temporarily if local codes allow. 
Follow package directions.
A short power-supply cord is provided to reduce risk of becoming entangled in 
or tripping over a longer cord.
Extension Cord
If it is necessary to use an extension cord, use only a 3-wire extension cord that 
has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug 
on the microwave oven. The marked rating of the extension cord should be AC 
115-120 volt, 15 amp. or more.
Be careful not to drape the cord over the countertop or table where it can be 
pulled on by children or tripped over accidentally.
Notes:
1. If you have any questions about the grounding or electrical instructions, consult 
a qualifi ed electrician or service person.
2. Neither Sharp nor the dealer can accept any liability for damage to the oven 
or personal injury resulting from failure to observe the correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven 
is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position 
and signal of receiving antenna.
G R O U N D I N G   I N S T R U C T I O N S
Permanent and Correct Installation
3-Prong Plug
3-Prong Receptacle
Grounded
Receptacle Box
Grounded
Receptacle Box
Unpacking and Examining Your Oven
1.  Remove all packing materials from inside the oven 
cavity. DO NOT REMOVE THE WAVEGUIDE 
COVER, which is located on the right cavity wall. 
Read enclosures and SAVE the Operation Manual.
2. Remove the feature 
sticker, if there is one, 
from the outside of 
the door.
Check the oven for 
any damage, such as 
misaligned or bent door, 
damaged door seals 
and sealing surfaces, 
broken or loose door 
hinges and latches 
and dents inside the 
cavity or on the door. 
If there is any damage, do not operate the oven and 
contact your dealer or SHARP AUTHORIZED 
SERVICER.
U N P A C K I N G   A N D   I N S T A L L A T I O N   I N S T R U C T I O N S
Choosing a Location for Your Oven
You will use the oven frequently so plan its location for ease 
of use. It's wise, if possible, to have counter space on at least 
one side of the oven. Allow at least 2 inches (50 mm) on the 
sides, top and at the rear of the oven for air circulation. 
Do not place or install the oven in any area where heat 
and steam are generated; for example, next to or above a 
conventional gas or electric range or above a conventional 
wall oven. Heat and steam may damage the electronics 
or the mechanical parts of the oven.
1126 R-308N, 307N_En.indd   5
1126 R-308N, 307N_En.indd   5
11/26/07   11:37:03 AM
11/26/07   11:37:03 AM