Tascam pro tools us-428 ユーザーズマニュアル

 

 

 

§  First, run the OMS installer.  If you do not have the current version of OMS, it may be 

freely downloaded at 

www.opcode.com

.  

 

§  Locate the “US-428 Drivers” folder, which was placed on your desktop when you ran the 

US-428 installer.  In this folder, locate the US-428 OMS driver.  Drag the US-428 OMS 
driver into the OMS folder inside your System folder.  Do not drag this file into the 
Opcode folder on your hard drive – it will not work correctly. 

 

§  Restart your computer.  Then turn on the US-428 and start the OMS Setup application 

(located in the Opcode folder on your hard drive). 

 

§  Select “New Studio Setup” from the File menu.  When prompted to select a serial 

(modem or printer) port, leave both selections unchecked.  Click yes and continue.  OMS 
will assess all the MIDI ports attached to your computer and build OMS instruments for 
the ones it recognizes. 

 

§  When the setup is complete you should see a list of all your connected MIDI ports.  At the 

least you should see four icons pertaining to the US-428 specifically: the US-428 icon, 
US-428 MIDI ports 1 and 2, and US-428 Control port. 

 
(Ports 1 and 2 correspond to the US-428’s physical MIDI ports.  US-428 Control is the “virtual” 
MIDI port with which the US-428 and its control surface communicate with your host application.) 
 
Once OMS setup is successfully completed, you can proceed with setting up the US-428 with 
your chosen application.  Please refer to the specific documentation for your application for 
specific details.