Ariens sno-thro 924126 st11526dle ユーザーズマニュアル
GB - 27
5. Release traction clutch lever, shift to third
(3) position, and remove friction disc.
6. Secure new friction disc on hub with five
cap screws and torque cap screws to
8-10 lbf-ft (10,6-13,3 N•m).
8-10 lbf-ft (10,6-13,3 N•m).
7. Replace bottom cover.
8. Adjust traction drive clutch (see Traction
8. Adjust traction drive clutch (see Traction
Drive Clutch Adjustment).
BATTERY (924516, 517)
Charging
1. Place unit on a level surface and shut off
engine.
2. Disconnect negative (-) cable first, then
positive (+) cable.
3. Loosen wing nut and remove battery.
Place battery on bench or other well
ventilated place.
ventilated place.
4. Connect positive (+) lead of charger to
positive (+) terminal, and negative (-) lead
to negative (-) terminal.
to negative (-) terminal.
5. Charge the battery at two and a half amps
for ten hours.
6. Reinstall battery into unit and connect
positive (+) cable first, then negative (-)
cable.
cable.
Replacing
Use U1R or U1L; 340 to 350 CCA @ 0°F type
batteries.
batteries.
SHORT TERM
IMPORTANT: NEVER spray unit with high
pressure water or store unit outdoors.
Run with attachment clutch engaged a few
minutes after each use to free unit of any loose
or melting snow.
Close fuel shut-off valve.
pressure water or store unit outdoors.
Run with attachment clutch engaged a few
minutes after each use to free unit of any loose
or melting snow.
Close fuel shut-off valve.
Inspect unit for visible signs of wear, breakage
or damage.
or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low
pressure water and lubricate (see
Maintenance). Touch up all scratched painted
surfaces.
pressure water and lubricate (see
Maintenance). Touch up all scratched painted
surfaces.
Remove weight from wheels by putting blocks
under frame or axle.
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to Engine Manual.
under frame or axle.
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to Engine Manual.
To obtain a complete parts manual, find your
model and serial number. Then go to
www.ariens.com or call 1-920-756-4664.
model and serial number. Then go to
www.ariens.com or call 1-920-756-4664.
* Available in CE countries.
STORAGE
WARNING: AVOID INJURY. Read and
understand the entire Safety section
before proceeding.
understand the entire Safety section
before proceeding.
1
2
3
4
5
Figure 25
6
OS0612
1. Cap Screw
2. Cotter Pin
3. Friction Disc
2. Cotter Pin
3. Friction Disc
4. Shift Arm
5. Chain
5. Chain
Idler Hex Shaft
SERVICE PARTS
Order the following parts through your Dealer:
Part No.
Description
00036800
Stens Mix Hi-Temp Grease (3, 3 oz.
cartridges)
cartridges)
21533500
Spark Plug
07200005
Impeller Belt (924128, 338, 516,
517)
517)
07200004
Impeller Belt (924124, 125, 126,
127, 335, 336, 337)
127, 335, 336, 337)
07211200
Traction Belt (124, 125, 126, 127,
335, 336, 337)
335, 336, 337)
07236100
Traction Belt (924128, 338, 516,
517)
517)
00170800
Friction Disc
51001500
Shear Bolt Kit
ACCESSORIES
See your authorized Ariens dealer to add the
additional accessories available to your
Sno-Thro.
additional accessories available to your
Sno-Thro.
Part No.
Description
72406500
Front Weight Kit