Patton electronic industrial ethernet extender with lcd interface 3231 ユーザーズマニュアル
Using the LCD Menu
20
Model 3231 User Manual
2 • Initial Configuration
Figure 4. Rear view of 3231
Using the LCD Menu
The following sections are options in the top level menu on the LCD interface:
•
Use this menu to configure the G.SHDSL link including line rate, I-bits, mode, annex, transmit gain, and
the ethernet link.
the ethernet link.
•
Use this menu to configure the LAN IP address, netmask, and default gateway.
•
Use this menu on the CO unit to configure the CPE unit.
•
Use this menu to configure STP. (STP prevents loops from occurring in a network).
•
Use this menu to configure the system, including the host IP address, facility settings, system password,
alarms, saving the current configuration, and the LCD screen contrast.
alarms, saving the current configuration, and the LCD screen contrast.
•
Password
If a password is set, a user must enter the password to access the LCD submenus. Enter an empty string to
remove the password.
If a password is set, a user must enter the password to access the LCD submenus. Enter an empty string to
remove the password.
•
Clear Alarms
Clear DSL, Ethernet, and any other alarm indications.
Clear DSL, Ethernet, and any other alarm indications.
•
Save Config
Save the current configuration to flash.
Save the current configuration to flash.
•
LCD Contrast
Adjust the contrast of the LCD screen. Use the Left and Right Arrown keys to adjust the contrast, then
press the Enter key to save your changes.
Adjust the contrast of the LCD screen. Use the Left and Right Arrown keys to adjust the contrast, then
press the Enter key to save your changes.
Ethernet
Reset
Line
Power
5V
, 1A
Console