Patton electronic forefront 2616rc ユーザーズマニュアル
Introduction
59
Model 2616RC T-DAC User Manual
4 • Operation and shutdown
Introduction
This chapter describes how to start up and power down the Model 2616RC.
Activating the Model 2616RC
The Model 2616RC is activated by completing the procedures in Chapter 2, “Hardware installation” and
Chapter 3, “Configuring the T-DAC for operation”. To activate the 2616RC, please follow the procedures in
those chapters.
Chapter 3, “Configuring the T-DAC for operation”. To activate the 2616RC, please follow the procedures in
those chapters.
The Model 2616RC is designed for unattended operation.Once the Model 2616RC has been installed and
configured, no further operator action is required under normal conditions.
configured, no further operator action is required under normal conditions.
De-activating the Model 2616RC
Perform the following procedure to deactivate the Model 2616RC.
Note
Be sure to wear an anti-static strap to prevent electrostatic damage to
the blade.
the blade.
1. Unlock the handles on the front of the 2616RC by pressing the red button on each handle. The button
immediately activates the switch (turning it to an open position), while the button itself remains depressed.
Remove the blade by pushing the handles outwards.
Remove the blade by pushing the handles outwards.
2. Remove the Model 2616RC from the rack chassis. Place the blade on an anti-static surface.
3. Remove the rear blade from the rack chassis. Place the blade on an anti-static surface.