Philips az1308-37b ユーザーズマニュアル
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated
into three materials: cardboard, polystyrene and plastic.
into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packaging, dead batteries and old equipment.
specialized company. Please observe the local regulations regarding the
disposal of packaging, dead batteries and old equipment.
Problem
–
Possible cause
• Remedy
No sound /power
–
Volume not adjusted
• Adjust the VOL
–
–
Power cord not securely connected
• Connect the AC power cord properly
–
–
Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
– Headphones connected to the set
• Disconnect headphones.
–
– Headphones connected to the set
• Disconnect headphones.
–
CD contains non-audio files
• Press TUNING
∞ , § once or more to skip to
a CD audio track, instead of the data file.
Display does not function properly / No
reaction to operation of any of the con-
trols
reaction to operation of any of the con-
trols
–
Electrostatic discharge
• Switch off and unplug the set. Reconnect after a
few seconds
Poor radio reception
– Weak radio signal
• FM: Adjust the FM telescopic aerial
• FM: Adjust the FM telescopic aerial
Nocd indication
–
No CD inserted
• Insert a CD
–
–
CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
–
–
Laser lens steamed up
• Wait until lens has cleared
–
–
CD-R/CD-RW is blank or not finalized
• Use a finalized CD-R/CD-RW or suitable CD
Audio disc only
Note:
Make sure the CD is not encoded with
Copyright protection technologies, as some
do not conform to the Compact Disc stan-
dard.
Make sure the CD is not encoded with
Copyright protection technologies, as some
do not conform to the Compact Disc stan-
dard.
The CD skips tracks
–
CD damaged or dirty
• Replace or clean CD
–
–
Program/Shuffle is active
• Quit program/shuffle mode
Sound skips during MP3 playback
– MP3 file made at compression level exceeding
– MP3 file made at compression level exceeding
320kbps
• Use a lower compression level to record CD
tracks into MP3 format
– Disc damaged or dirty
• Replace or clean disc
• Replace or clean disc
The MP3-CD skips albums
– CD contains non-MP3 file folders
• Check your disc contains suitable file folders.
– CD contains non-MP3 file folders
• Check your disc contains suitable file folders.
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
Canada
English:
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as
set out in the Radio Interference Regulations of the Canadian Department of Communications.
set out in the Radio Interference Regulations of the Canadian Department of Communications.
Français :
Cet appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils
numériques de Classe B prescrites dans le Règlement sur le Brouillage Radioélectrique édicté par le
Ministère des Communications du Canada.
Cet appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils
numériques de Classe B prescrites dans le Règlement sur le Brouillage Radioélectrique édicté par le
Ministère des Communications du Canada.