Philips mcd280-21m ユーザーズマニュアル

29

1

Select TUNER source.

➜

“

TUNER” is displayed briefly.

2

Press BAND to select the desired waveband :
FM or MW.

3

Press and hold  

S or ¢ (or 22 / 33

on the remote control) and then release it.

➜

The display will show "

SEARCH" until a radio

station with sufficient signal strength is found.

4

Repeat step 3 if necessary until you find the
desired station.

●

To tune to a weak station, press  

S or ¢

(or 

22 / 33 on the remote control)  briefly

and repeatedly until you have found optimal
reception.

You can store up to 40 radio stations in the
memory (20 for FM and 20 for MW).

Press PROGRAM for more than two seconds
to activate programming.

➜

All available stations are programmed.

➜

AUTO is displayed and available stations are

programmed in order of waveband.

1

Tune to your desired station (refer to
“Tuning to radio stations”).

2

Press PROGRAM to activate
programming.

➜

PROG flashes on the display.

3

Press 

4 or 3 to allocate a number from 1

to 20 for this station.

4

Press PROGRAM again to confirm the
setting.

➜

PROG disappears, the preset number

and the frequency of the preset station are
shown.

5

Repeat the above four steps to store other
stations.

●

You can override a preset station by storing
another frequency in its place.