Philips VR1010 ユーザーズマニュアル
— 9 —
Setting the Video Channel
This VCR is designed to send picture and sound signal on UHF channel 38 (597.25 MHz) to the TV, through the RF
coaxial cable.
For customers in Australia;
If you want to change this video channel (38) to another channel (between 28 to 60), follow the procedure below before
turning on the VCR for the first time.
For customers in New Zealand;
Be sure to set video channel (between 28 to 60) by following the procedure below before turning on the VCR for the first
time.
coaxial cable.
For customers in Australia;
If you want to change this video channel (38) to another channel (between 28 to 60), follow the procedure below before
turning on the VCR for the first time.
For customers in New Zealand;
Be sure to set video channel (between 28 to 60) by following the procedure below before turning on the VCR for the first
time.
1
Make sure the VCR is turned off and no cassette inserted.
2
Turn on the TV, and tune it to any channel (UHF 28 to 60) you want to use as the video channel on the TV.
• Select a channel not used in your area.
3
Press
STOP/EJECT
7
/
0
on the front panel for more than 5 seconds.
The following indication appears on the display.
4
Press
CH
5 / ∞ on the front panel to select an appropriate TV system number for your area.
1. For B/G. (For West Europe, ASEAN countries, New Zealand)
2. For D/K. (For China, Russia, East Europe)
3. For I. (For Hong Kong, South Africa, United Kingdom)
4. For H. (For Australia)
5. For M. (For USA, Canada, Mexico, Japan, Latin America Countries, Korea, Taiwan, Philippines)
2. For D/K. (For China, Russia, East Europe)
3. For I. (For Hong Kong, South Africa, United Kingdom)
4. For H. (For Australia)
5. For M. (For USA, Canada, Mexico, Japan, Latin America Countries, Korea, Taiwan, Philippines)
5
Press
OK/STATUS
.
The channel number starts flashing on the display.
6
Press
CH
5 / ∞ on the VCR to select the channel you have tuned on the TV as the video channel in step 2.
A test signal (two vertical white bars) appears on the TV.
7
Press
OK/STATUS
to finish the video channel setting.
Now you will enter the Initial Setup mode explained on page 9.
To watch a picture from this VCR on the TV, select the same channel you have selected as the video channel (in step 2
above) on the TV.
above) on the TV.
TV system number starts flashing.
Test signal
(two vertical white bars)
(two vertical white bars)
Channel number starts flashing.
S
ETTING
U
P
If you use only external video input (AV) mode to
watch the picture from this VCR, you can turn off
the video channel output. To turn off the video
output channel, press
watch the picture from this VCR, you can turn off
the video channel output. To turn off the video
output channel, press
CH
∞
until “– –” appears on
the channel number position.
vr1010/75
00.6.29, 4:53 PM
9