Philips VRX364AT ユーザーズマニュアル
Watching TV With the VCR Off
1
Use the TV channel selector to set the TV to the Cable
Box/DSS Receiver output channel (channel 3 or 4).
Box/DSS Receiver output channel (channel 3 or 4).
2
Select the channel you want to watch at the Cable
Box/DSS Receiver.
Box/DSS Receiver.
Timer Recordings
With this connection, you may set a timer recording as described
on pages 34-37. However, you must remember the following:
on pages 34-37. However, you must remember the following:
●
You can only program a timer recording for one channel at a
time.
time.
●
Set the TV and the VCR to the Cable Box/DSS Receiver out-
put channel (channel 03 or 04).
put channel (channel 03 or 04).
●
When you are prompted to enter the channel you want to
record, select channel 03 or 04 (the Cable Box/DSS Receiver
output channel). (This is step 5 on page 35.)
record, select channel 03 or 04 (the Cable Box/DSS Receiver
output channel). (This is step 5 on page 35.)
●
Set your Cable Box/DSS Receiver to the channel you want to
record.
record.
●
Leave the Cable Box/DSS Receiver on while you are recording.
8 Hookups With a Cable Box/Digital Satellite System
This connection allows you to view any channel. After you connect the Cable Box/Digital
Satellite System, VCR, and TV as shown below, the features described on this page will be
available.
Satellite System, VCR, and TV as shown below, the features described on this page will be
available.
CH3
CH4
OUT
IN
ANT
R
L
VIDEO
IN
OUT
IN
OUT
AUDIO
OUT
IN
ANTENNA IN Jack
Back of TV
(example only)
1. Connect a Cable signal to the
IN Jack on the Cable Box/DSS
receiver.
IN Jack on the Cable Box/DSS
receiver.
3. Use a second RF coax-
ial cable to connect the
OUT Jack on the VCR to
the TV’s ANTENNA IN
Jack.
ial cable to connect the
OUT Jack on the VCR to
the TV’s ANTENNA IN
Jack.
• With this hookup, channels cannot
be changed at the VCR. You must
select channels at the Cable
Box/DSS Receiver.
select channels at the Cable
Box/DSS Receiver.
• You can not view a channel other
than the one you are recording (the
instructions on page 32 do not work
with this hookup).
instructions on page 32 do not work
with this hookup).
• You cannot program channels with
this hookup (as discussed on page
12).
12).
2. Use an RF coaxial cable (supplied) to connect
the OUT Jack on the Cable Box/DSS receiver to
the ANT(enna) IN Jack on the VCR.
the OUT Jack on the Cable Box/DSS receiver to
the ANT(enna) IN Jack on the VCR.
Helpful Hints
Recording/Viewing Any Channel
1
With the VCR on and in VCR position (the VCR light will appear
on the display panel), use the CHANNEL (Up/Down) but-
tons or the Number buttons to set the VCR to the Cable
Box/DSS Receiver output channel (channel 03 or 04).
on the display panel), use the CHANNEL (Up/Down) but-
tons or the Number buttons to set the VCR to the Cable
Box/DSS Receiver output channel (channel 03 or 04).
2
Set the TV to the same channel to which you set the VCR.
3
Select the channel you want to watch or record at the
Cable Box/DSS Receiver.
Cable Box/DSS Receiver.