Philips VRX360AT ユーザーズマニュアル
8 Hookups With a Cable Box
This connection allows you to view any channel. After you connect the Cable Box, VCR, and
TV as shown below, the features described on this page will be available.
TV as shown below, the features described on this page will be available.
75
V
ANT /
CABLE
CH3
CH4
OUT
IN
ANT
R
L
VIDEO
IN
OUT
IN
OUT
AUDIO
OUT
IN
ANTENNA IN Jack
Back of TV
(example only)
1. Connect Cable signal to
IN Jack on Cable Box.
3. Use a second RF
coaxial cable to con-
nect the OUT jack on
the VCR to the TV’s
ANTENNA IN Jack.
coaxial cable to con-
nect the OUT jack on
the VCR to the TV’s
ANTENNA IN Jack.
Recording and Viewing a Scrambled or
Unscrambled Channel
1
With the VCR on and in VCR position (the VCR light will appear
on the display panel), use the CHANNEL (Up/Down) but-
tons to set the VCR to the Cable Box output channel
(channel 3 or 4).
on the display panel), use the CHANNEL (Up/Down) but-
tons to set the VCR to the Cable Box output channel
(channel 3 or 4).
2
Set the TV to the same channel to which you set the
VCR.
VCR.
3
Select the channel you want to watch or record at the
Cable Box.
Cable Box.
Watching TV With the VCR Off
1
Use the TV channel selector to set the TV to the Cable Box
output channel (channel 3 or 4).
output channel (channel 3 or 4).
2
Select the channel you want to watch at the Cable Box.
Timer Recordings
With this connection, you may set a timer recording as described
on pages 30-33. However, you must remember the following:
on pages 30-33. However, you must remember the following:
●
You can only program a timer recording for one channel at a
time.
time.
●
Set the TV and the VCR to the Cable Box output channel
(channel 3 or 4).
(channel 3 or 4).
●
When you are prompted to enter the channel you want to
record, select channel 3 or 4 (the Cable Box output channel).
(This is step 5 on page 31.)
record, select channel 3 or 4 (the Cable Box output channel).
(This is step 5 on page 31.)
●
Set your Cable Box to the channel you want to record.
●
Leave the Cable Box on while you are recording.
• With this hookup, channels cannot
be changed at the VCR. You must
select channels at the Cable Box.
select channels at the Cable Box.
• You can not view a channel other
than the one you are recording (the
instructions on page 28 do not work
with this hookup).
instructions on page 28 do not work
with this hookup).
• You cannot program channels with
this hookup (as discussed on page
12).
12).
2. Use RF coaxial cable (supplied) to
connect OUT Jack on Cable Box to
ANT(enna) IN Jack on VCR.
Helpful Hints