Cisco Cable low-loss 6m + RP-TNC connector AIR-CAB020LL-R ユーザーズマニュアル
製品コード
AIR-CAB020LL-R
Antenna Cabling
Document ID: 27222
Introduction
Prerequisites
Requirements
Components Used
Conventions
Antenna Cable
NetPro Discussion Forums − Featured Conversations
Related Information
Prerequisites
Requirements
Components Used
Conventions
Antenna Cable
NetPro Discussion Forums − Featured Conversations
Related Information
Introduction
This document provides information for the installation of antennas on Cisco Aironet products.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Aironet wireless products
•
Installation of wireless products
•
Components Used
The information in this document is based on these software and hardware versions:
Aironet access points (APs) and bridges
•
Aironet antennas and accessories
•
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Antenna Cable
You must place the antennas in a wireless network installation close to the users. The location of the antennas
do not need to be close to the connected switch or to a computer room. The cable run can be 100 feet or more
from the AP or bridge to the antenna locations.
do not need to be close to the connected switch or to a computer room. The cable run can be 100 feet or more
from the AP or bridge to the antenna locations.