Maytag mah22pdagw0 ユーザーズマニュアル

■

A sturdy and solid floor to support the washer with a total 
weight (water and load) of 180 kg (400 lbs).

Do not operate your washer in temperatures below 0°C (32°F). 
Some water can remain in the washer and can cause damage 

 

in low temperatures. 

■

The location must be large enough to allow the washer door 
to be fully opened.

■

Additional spacing should be considered for ease of 
installation and servicing. The door opens more than 90° 

 

and it is not reversible.

■

Additional clearances might be required for wall, door, and 
floor moldings.

■

Additional spacing of 25 mm (1") on all sides of the washer 

 

is recommended to reduce noise transfer.

■

Companion appliance spacing should also be considered.

■

When installed, the mains plug should be accessible for 
washer disconnection from the mains supply. 

A floor drain should be provided under the bulkhead. 
Prefabricated bulkheads with electrical outlets, water 

 

inlet lines, and drain facilities should be used only where 

 

local codes permit.  

The washer can be installed using the standpipe drain system 
(floor or wall), the laundry tub drain system, or the floor drain 
system. Select the drain hose installation method you need. 

 

See “Tools and Parts.” 

The standpipe drain requires a minimum diameter standpipe of 
50 mm (2"). The minimum carry-away capacity can be no less 
than 64 L (17 gal.) per minute.

The top of the standpipe must be at least 762 mm (30") high and 
no higher than 2.4 m (96") from the bottom of the washer. 

The laundry tub needs a minimum 76 L (20 gal.) capacity. The top 
of the laundry tub must be at least 762 mm (30") above the floor. 

The floor drain system requires a siphon break that may be 
purchased separately. See “Tools and Parts.”

The siphon break must be a minimum of 710 mm (28") from the 
bottom of the washer. Additional hoses might be needed.