Maytag mat12prb ユーザーズマニュアル

14

16022842   Rev. 0

©2003 Maytag Appliances Company

To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing
requires power.

A motor test cord may be used to electrically check operation of the various electrical components without removing
them from the unit.  Testing in this manner merely determines whether or not part will function independently of other
electrical components.  In order to make accurate test, proper connection of the motor test cord is important.

All four leads of the test cord are required to test the washer drive motor.  The following drawing shows installation of
the test cord on washer drive motor.  Reversing the motor from agitation to spin is accomplished by reversing the test
cord wires B and C.

 

 

 

Pressure Switch 

Disconnect wire terminals from switch. 
Measure resistance across the 
following terminals: 
Empty (Filling) 20 to 15--------------------  
 
Full (Run) 20 to 15 ------------------------- 

Resistance above 2 

Ω

 indicates dirty 

switch contacts. 
 
Closed circuit  
 
Open circuit 

 

Water Valve 

Measure resistance across the 
terminals of each coil on the valve. 
 
 

 Approximately 850-950 

Ω

 

 

Motor 

Type of Motor: 
Single speed (Split phase)  

 

Pump 

Verify drain pump is not clogged or 
damaged 

1) Remove clog and verify proper 
operation 
 
2) Replace drain pump if damaged 

Transmission 

Type of transmission (orbital): 
   618 r.p.m. Spin 
   150 o.p.m. Agitate 
 
Check wattage with full tub of water 
only (Use Wattage Meter) 

See “Transmission” Disassembly 
Procedures section. 
 
380 to 420 watts 

 

Belts 

Check belt for excessive wear or being 
burnt and cracking 

Replace if belt if damaged