Maytag mat12prd ユーザーズマニュアル

20

16022842  Rev. 0

©2003 Maytag Appliances Company

To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

3. Remove coin box.
4. Remove timer or disconnect wires to Service and Vault

Switches.

2.  Unlock service access door.
3.  Loose the two locking bolts from inside the meter

case.

4.  Remove Coin Drop Acceptor.
5.  Remove screw securing Coin Sensor to the rear of the

Coin Drop Acceptor.

1.  Disconnect power supply  to unit.
2.   Remove Service Access Door.

1. Disconnect power supply to unit.
2. Remove screw holding Valve Bracket to back panel.
3. Pivot out until flange clears back and lift up to

disengage the bracket from the slot on the back
panel.

4. Remove two screws holding Water Valve to mounting

bracket.

5. Disconnect wires from terminals.
6. Remove injector hose.

5.  Remove Control Panel.
6.  Remove screws securing console to meter case.
7.  Remove two nuts (one inside coin box area and inside

service access door compartment.).

1.  Disconnect power supply to unit.
2.  Unlock and remove service access door.
3.  Loosen the locking bolt from inside the meter case.
4.  Pull the coin slide out of the Meter Case.
Note:

The timer Actuator can be adjusted once the

Coin slide is removed.  The holes on the actuator
are slotted to allow proper length adjustments
(the actuator must be adjusted for the particular
coin slide to advance the timer into the cycle).

1. Disconnect power supply to unit.