Maytag mat12prd ユーザーズマニュアル

28

16022842  Rev. 0

©2003 Maytag Appliances Company

To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

Note:

When the drive Pulley is replaced, the Drive Lug

must be properly positioned.

1. Disconnect power supply to unit.
2. Remove Drive and Pump Belts and Dust Cap covering

hub of Pulley.

3. Remove screw and washer from bottom of Drive Shaft.
4. Remove the splined Drive Lug from the Drive shaft.
5. Turn pulley counterclockwise to remove it from the

Helical Shaft.  The Rotor Bearing is located above the
drive pulley.

There is a top and bottom to the rotor bearing.

When it is positioned correctly, the top of the
Bearing and the Pulley hub will be about even
(the concave side against Pulley hub).

6. After Brake Package has been removed, the Radial

Bearing may be removed from top of Brake package.

5. Use a hammer to remove the Brake Package.

4. Use the Brake Tool to unscrew the Brake Package

assembly from the Damper.  When the Brake
Package is free, pull out to disengage it from the
spline surface of the drive tube.

1. Disconnect power supply to unit.
2. Remove front Panel.
3. Tilt machine backwards.
4. Roll Pump Belt than Drive Belt off pulleys.

To reduce the risk of serious injury or death to persons
when using your washer, make sure the Rotor Bearing
is not put on upside down.  You will have no Brake.