Maytag mde-mdg21pra ユーザーズマニュアル
50
16022904 Rev. 0
©2004 Maytag Appliances Company
WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
disconnect power to unit before servicing.
Disassembly Procedures
Service
Switch
Wires
STACK DRYER SLOPED FRONT MODELS
Note:
The following section is exclusive to the stack
dryers.
Service Panel and Switch
1. Disconnect power to the machine.
2. Remove three security screws.
2. Remove three security screws.
Remove Security Screws
Service
Lock
3. Unlock the service lock.
4. Pull the service panel down.
Access Cover
1. Disconnect power to unit.
2. Remove the Access Panel.
3. Locate and remove the 5/16" hex head screw located
2. Remove the Access Panel.
3. Locate and remove the 5/16" hex head screw located
in the front of the dryer base frame
. This screw
secures the access cover to the base frame.
4. Open the door.
5. Carefully slide the access cover down and away from
5. Carefully slide the access cover down and away from
the machine to disengage the cover from retaining
clips on the front shroud located above the front panel
goal posts.
clips on the front shroud located above the front panel
goal posts.
Control Panel
1. Disconnect power to the machine.
2. Remove the Access Panel.
3. Remove three security and two pozi drive screws
2. Remove the Access Panel.
3. Remove three security and two pozi drive screws
securing the Control Panel under the Console.
Blower
Housing
Housing
Access
Cover
Cover
Screw
Front Panel
Slide
Access Cover
Access Cover
Hook
Hook
5. Disconnect wires to service switch.