mk-diamond-products mk-sdg e1 ユーザーズマニュアル

MK-SDG

Revision 09/05, Effective Date September 30, 2005

To avoid the possibility of the appliance plug or receptacle getting wet, position the saw to one side of a

wall mounted receptacle. This will prevent water from dripping onto the receptacle or plug. A “drip loop,”

shown in FIGURE 2, should be arranged by the user to properly position the power

cord relative to the power source.

The “drip loop” is that part of the cord below the level of the receptacle, or the

connector, if an extension cord is used. This method of positioning the cord prevents

the travel of water along the power cord and coming in contact with the receptacle.

If the plug or receptacle gets wet, DO NOT unplug the cord. Disconnect the fuse or

circuit breaker that supplies power to the tool. Then unplug and examine for presence

of water in the receptacle.

WARNING

Use of under size extension cords result in low voltage to the motor that can result in motor burnout

and premature failure. MK Diamond warns that equipment returned to us showing signs of being run

in a low voltage condition, through the use of undersized extension cords will be repaired or replaced

totally at the customers expense. There will be no warranty claim.

To choose the proper extension cord,

• Locate the length of extension cord needed in TABLE 1 below.

• Once the proper length is found, move down the column to obtain the correct AWG size required

for that length of extension cord.

WARNING

To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the

plug with wet hands.

WARNING

Use only extensions cords that are intended for outdoor use. These extension cords are identified

by a marking “Acceptable for use with outdoor appliances; store indoors while not in use.” Use

only extension cords having an electrical rating not less than the rating of the product. Do not use

damaged extension cords. Examine extension cords before using and replace if damaged. Do not

abuse extension cords and do not yank on any cord to disconnect. Keep cords away from heat and

sharp edges. Always disconnect the extension cord from the receptacle before disconnection the

product form the extension cord.

FIGURE 2

Extension Cord Minimum Gage for Length

Volts

Total Length of Cord in Feet

220 V

25 ft.

50 ft.

100 ft.

150 ft.

AWG

Not Recommended

TABLE 1

SAFETY

Drip Loop