Mercedes Benz 2007 sl 550 ユーザーズマニュアル
62
Getting started
Parking and locking
Turning off the engine
왘
Place the gear selector lever in
position P.
position P.
왘
Apply the parking brake (
Turning off with the SmartKey
왘
Turn the SmartKey in the starter switch
to position 0 (
to position 0 (
왘
Remove the SmartKey from the starter
switch.
switch.
The immobilizer is activated.
Turning off with KEYLESS-GO*
왘
Place the gear selector lever in
position P.
position P.
왘
Press the KEYLESS-GO start/stop but-
ton (
ton (
page 40) to turn off the engine.
With the driver’s door closed, the start-
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
(
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
(
Releasing seat belts
왘
Press the seat belt release button
(
(
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
wind the seat belt by guiding the latch
plate.
i
Always set the parking brake in addition to
shifting to position P.
On slopes, turn the front wheels towards the
road curb.
road curb.
i
The SmartKey can only be removed from the
starter switch with the gear selector lever in
position P.
position P.
i
With the SmartKey removed and the driver’s
door open, a warning sounds if the vehicle’s
exterior lamps are not switched off.
exterior lamps are not switched off.
i
If you hear a warning signal you have tried to
turn off the engine while the gear selector lever
was not in P.
was not in P.
In addition, the message
Gear selector
lever to P
appears in the multifunction dis-
play.
Place the gear selector lever in position P.
!
Make sure the seat belt retracts fully so that
the seat belt and/or latch plate cannot get
caught or pinched in the door or in the seat
mechanism. This can damage the seat belt and
impair the effectiveness of the seat belt, and/or
cause damage to the door and/or door trim
panel. Such damage is not covered by the
Mercedes-Benz Limited Warranty.
caught or pinched in the door or in the seat
mechanism. This can damage the seat belt and
impair the effectiveness of the seat belt, and/or
cause damage to the door and/or door trim
panel. Such damage is not covered by the
Mercedes-Benz Limited Warranty.
Damaged seat belts must be replaced. Contact
an authorized Mercedes-Benz Center.
an authorized Mercedes-Benz Center.