ONKYO dr-2000 ユーザーズマニュアル

63

You can program the supplied remote controller (RC-437M) to
operate your TV.

DVD Receiver's
remote controller

TV’s remote control

Must be 5 cm to 10 cm
apart

Programming is carried out by copying the signal patterns of
the TV’s remote control buttons.

• If the SEND/LEARN indicator flashes three times, the programming

is unsuccessful. Repeat from step 2.

• Use new batteries for the remote controller and the TV’s remote

control. Using old batteries may result in a failure in programming or
cause the programmed remote controller buttons to operate
improperly.

• The remote controller and most other remote controls transmit

infrared rays, however, if the other remote control uses another
method, programming is impossible.

• Although seven buttons are prepared for operating the TV, the

number of programmable buttons varies depending on the
manufacturer and type of the other remote control.

• Switch off the main power of the DVD Receiver and TV to prevent

the units from undesired operation during programming.

• The remote control buttons on some TVs may have more than one

function; however, only one function can be programmed per button.

• Refer also to the TV’s instruction manual for details on its remote

control operation and other information.

At the same

time

Lights up.

The SEND/LEARN indicator lights up and
the remote controller enters the
programming mode.

Proceed to the next step within 30
seconds.

The programmed buttons of the DVD Receiver's remote controller
may lose their data if the batteries become weak or dead, or due to
other causes. In such a case, you need to repeat programming from
the beginning using the TV's remote control. Therefore, keep the TV's
remote control in a safe place even if it is not in use.