Olympus WS-500M ユーザーズマニュアル

ページ / 72
12
1
Power supply
Po
we
r s
u
p
p
ly
Charging by connecting to a 
computer via USB
You can charge the batteries by connecting 
to a PC's USB port.  When charging, be sure 
to correctly place the rechargeable batteries 
(supplied) into the recorder (
☞ P.10).
 
1
  Boot the PC.
 
2
  Slide the USB connector slide 
lever in the direction indicated 
by the arrow to eject the USB 
connector out of the recorder.
 
3
  While pressing the STOP 
4 
button, connect to the PC’s USB 
port.
 Notes
•  The recorder cannot be charged when the 
PC is not turned on. Also, it may not be 
charged when the PC is in standby mode.
•  Do not charge the recorder with the USB 
hub connected.
• If [Cannot charge] is displayed, it means 
that a battery that cannot be charged is 
in the recorder. Replace the batteries with 
supplied ones at once (
☞ P. 10).
•  Charging is completed when battery 
indication becomes to [
<] (charging time: 
approximately 3 hours *).
  *  It shows the approximate time when 
charging the rechargeable battery fully 
from no remaining power at the room 
temperature. The charging time will be 
changed depending on the remaining 
amount and the state of batteries.
•  You cannot charge when [
;]* or [=]** 
blinks. Charge the batteries at the 
temperature from 5°C to 35°C (41°F to 95°F).
*  [
;]:  When surrounding temperature is 
lower than 5°C (41°F).
** [
=]:  When surrounding temperature is 
higher than 35°C (95°F).
•  When using time becomes notably short 
even after the batteries are fully charged, 
replace them with new ones.
•  Be sure to push the USB connector all the 
way in. Otherwise, the recorder may not 
operate properly.
•  Use the supplied USB extension cable 
depending on situations.
"
  For WS-500M: