Motorola i315 ユーザーズマニュアル
23
Channels and Codes
Making and Receiving Code Calls in
Mike’s Talkaround
Mike’s Talkaround
To make a code call in Mike’s Talkaround:
1 Press and hold the PTT button. TA Transmit
appears on the first line of display. Begin
speaking after your phone emits the Mike’s
Talkaround tone.
speaking after your phone emits the Mike’s
Talkaround tone.
2 Release the PTT button to listen.
The tone emitted from your phone when using
Mike’s Talkaround is 4 beeps and sounds different
from the standard tone heard with on-network
Private and group calls.
Mike’s Talkaround is 4 beeps and sounds different
from the standard tone heard with on-network
Private and group calls.
If you receive an error message:
• There may be no parties on your channel or code.
• You are out of range.
When you receive a code call using Mike’s
Talkaround, TA Receive appears on the first line of
the display.
Talkaround, TA Receive appears on the first line of
the display.
Note: An incoming Mike’s Talkaround call can be
terminated at any time by pressing
e
.
Receive All
You can set your phone to receive Mike’s
Talkaround transmissions from any phone that is set
to the same channel, regardless of the code (1-15),
by setting the code to Receive All. When you
receive transmissions with the code set to Receive
All, the display changes from Receive All to the
code on which the transmission was received.
Talkaround transmissions from any phone that is set
to the same channel, regardless of the code (1-15),
by setting the code to Receive All. When you
receive transmissions with the code set to Receive
All, the display changes from Receive All to the
code on which the transmission was received.
Tip: You can reply to an incoming call within 6
seconds after hearing the short ending beep
by pressing the PTT button.
by pressing the PTT button.
Note: You cannot initiate a code call when the
code is set to Receive All. If you press the
PTT button with the code set to Receive
All, you will receive an error message.
PTT button with the code set to Receive
All, you will receive an error message.
To set the code to Receive All:
1 From the Talkaround idle screen, press
A
under
Edit.
2 Scroll to Code.
3 Press
3 Press
A
under Edit.
4 Select Receive All.
5 When you are finished, press
5 When you are finished, press
A
under Back to
return to the Talkaround idle screen.