Cub Cadet tank 60 ユーザーズマニュアル

IMPORTANT: This unit is shipped without gasoline or oil 
in the engine. Be certain to service engine with gasoline 
and oil as instructed in the separate engine manual 
before operating your machine.

a.  Upper and Lower Handle
b.  Hose Assembly
c.  Safety Glasses
d.  Engine Oil (May be located in bag)
e.  Bag

NOTE: All references in this manual to the left or right 
side of the chipper shredder vacuum is from the operating 
position only. Exceptions, if any, will be specified.

1.  Remove the hairpin clips from the handle brackets and 

remove the carriage screws and wing nuts from the 
lower handle.
a.  Place the bottom holes in lower handle over the 

pins on the handle brackets and secure with 
hairpin clips. See Figure 3-1.

b.  Insert carriage screws through upper hole in lower 

handle from the inside and secure with wing nuts. 
See Figure 3-1.

2.  a. Unfold the upper handle until it aligns with lower 

handle. Make sure the rope guide is on the right 
side of upper handle. See Figure 3-2.

IMPORTANT: Make sure the cables are routed outside 
the lower handle. Also, do not crimp the cables while 
lifting up the handles.

  b. Secure the two handles by tightening the star 

knobs (carriage bolts must be seated properly into 
the handle). See Figure 3-2.

3.  Pull the two cable ties attached to the cables tight 

approximately 8 inches from each cable end and place 
the cables into the cable guide.

4.  Loosen the wing nut that secures the rope guide to the 

right side of upper handle.
a.  Slowly pull starter rope out of engine.

  b. Slip the starter rope into the rope guide. Tighten the 

wing nut. See Figure 3-3.

A

B