Multi-Tech Systems MT5600BA-V92 ユーザーズマニュアル

Chapter 4 – Leased Line Operation 

Multi-Tech Systems, Inc. MT5600BA-V92 User Guide 

            

 

 
This chapter describes how to use the MultiModem II modem on a leased line.  
A leased line is a private, permanent, telephone connection between two points. Unlike normal dialup 
connections, a leased line is always active. The modems automatically connect when they are attached 
to the line and are turned on. Because a leased line is always active, one of the two modems on the line 
must be configured as the originate modem and the other as the answer modem; it does not matter which 
is which. 
In the event of an interruption, leased line modems automatically reconnect when the data line or power 
is restored. The modem also supports dial backup, which enables the modem to automatically switch to a 
dial-up connection if the leased line goes down. 
The modem supports both two-wire and four-wire leased-line operation.  

1.  For leased line operation, plug one end of a two-wire phone cable into the modem’s LEASED 

jack. Connect the other end to a leased line wall jack or terminals.  

2.  Turn on the modem. 

3.  Starting at the STATUS LCD, press the following buttons on the front panel: È, Æ, È, È, È, 

Æ

. The CURRENT SETTING= LCD appears. 

4. If 

the 

LCD shows ASYNC AT, press ÇÅ and go to step 7. If it shows 

anything else, press Æ to go to the ASYNC, NORM? LCD. 

5. Press 

the 

button to select normal asynchronous operation. 

6. The 

 LCD appears. Press ÇÅ to exit to the SYNC/ASYNC OPTIONS LCD. 

7. Press 

ÇÅ

, ÇÅ, ÇÅ, Æ, Æ, Æ, Æ. The 2 WIRE LEASE? ORIG LCD appears. 

8.  Choose one of two actions: 

• 

To set up the modem as the originate modem, press the Enter button.  

• 

To set up the modem as the answer modem, press Æ to display the 2 WIRE 
LEASE? ANSWER 

LCD, and then press the Enter button.  

 

One of the modems in a leased line pair must be configured as the originate 

modem, and the other as the answer modem, but it does not matter which is which. 

9. The 

 LCD appears. Press ÇÅ to exit to the ONLINE OPTIONS LCD, or Æ to 

exit to the CURRENT SETTING= LCD to verify the selection. 

10.  This completes the setup for two-wire leased line operation. Upon completion, the modem 

attempts to connect to the modem at the other end of the leased line. If the remote modem 
has not yet been configured for leased line operation, you may turn off the local modem until 
the remote one is ready.