Multiquip dca25ssiu3 ユーザーズマニュアル

1. Place 

the 

main, G.F.C.I., and aux. circuit breakers (Figure 

36) in the OFF position prior to starting the engine.

2.  Make sure the voltage change-over board has been 

confi gured for the desired output voltage.

3.  Connect the load to the receptacles or the output 

terminal lugs as shown in Figure 11. These load 
connection points can be found on the output terminal 
panel and the output terminal panel’s hard wire hookup 
panel. 

4.  Tighten terminal nuts securely to prevent load wires 

from slipping out.

5.  Close all engine enclosure doors (Figure 37).

The engine’s exhaust contains harmful emissions. 
ALWAYS have adequate ventilation when operating. 
Direct exhaust away from nearby personnel.

NEVER manually start the engine with the main, GFCI 
or auxiliary circuit breakers in the ON (closed) position.

INCORRECT

CORRECT

1. Place 

the voltage selector switch in the desired 

voltage position (Figure 38)..

1.  In warm weather conditions, skip to step 3. In cold 

weather conditions, preheat the engine glow plugs by 
turning the ignition key (Figure 39) to the RUN 
position..

2.  Depending on the temperature of the coolant (cold 

weather conditions), the pre-heat lamp (Figure 40) will 
light (ON) and remain on until the pre-heating cycle has 
been completed. After completion of the pre-heating 
cycle, the light will go OFF and the engine will start up 
automatically.