Hitachi wh9dm ユーザーズマニュアル
English
12
Fig. 3
Fig. 4
ASSEMBLY AND OPERATION
APPLICATIONS
䡬 Driving and removing of small screws, small bolts, etc.
REMOVAL AND INSTALLATION METHOD OF BATTERY
䡬 How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may acciden-
tally fall out of the tool, causing injury to
you or someone around you. (Fig. 3)
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may acciden-
tally fall out of the tool, causing injury to
you or someone around you. (Fig. 3)
䡬 How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch on the side of the battery.
(Fig. 3)
pressing the latch on the side of the battery.
(Fig. 3)
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
䡬 The power source voltage is stated on the nameplate.
䡬 The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical
cord if damaged. Have
it repaired immediately.
cord if damaged. Have
it repaired immediately.
Handle
Latch
Rechargeable
battery
battery
Battery
Pilot lamp
Pull out
Insert
Battery
installation
hole
installation
hole