Chamberlain WKP5LM ユーザーズマニュアル

2

Enter existing Master PIN Number on Keypad:

Enter new Master PIN Number:

To use Keypad, enter any valid PIN Number. With 
multiple Receivers, enter the PIN Number followed by 
the Receiver Identity (1-4).

Step 1: Pry open the front 
panel of the receiver case 
with a coin or a screwdriver.

Step 2: Press and release 
the Learn button on the 
receiver. The Indicator Light 
will light for 30 seconds 
indicating that receiver is in 
Learn Mode.

Step 3: Within 30 seconds enter Master PIN Number 
on Keypad.

Step 4: Press “1”.

Repeat Steps 2-4 for each remote, or control device 
that will be used to access the Liftmaster door or gate 
operator.

Press and hold the Learn button on the receiver until 
the Indicator Light turns off indicating that the receiver 
memory is clear (about 6 seconds).

Indicator Light

Learn Button

A temporary PIN Number can be used only once 
within a 24 hour period.
NOTE: The WKP5LM can hold up to 5 Temporary 
PIN Numbers while the WKP250LM can hold 15.

Enter Master PIN Number on Keypad:

Enter temporary PIN Number:

If the temporary PIN Number applies only to a certain 
Receiver, enter the PIN Number followed by the 
Receiver Identity (1-4). The result will be a five digit 
PIN Number (example: 12341).

The WKP5LM can support up to 5 PIN Numbers 
while the WKP250LM can support 250.

Enter Master PIN Number on Keypad:

Enter new PIN Number:

Enter Master PIN Number on Keypad:

Enter PIN number you want to remove:

A triple beep indicates a PIN Number has been 
entered that does not exist. The Master PIN Number 
cannot be deleted.