Denso ofice pro 36 ユーザーズマニュアル

INSTALLATION (cont.)

Plugging in the Unit

1. Check the prong and surface of the power cord plug for dust/dirt. If dust and/

or dirt are present, wipe off with a clean, dry cloth.

2. Check the power cord, plug and prong for damage or excess play. If any

damage or excess play is found, contact your MovinCool reseller for repair.

WARNING:

1. If the power cord or plug is damaged, repair should only be

performed by qualified electrical personnel.

2. Do not connect/disconnect the power cord or attempt to operate

buttons with wet hands. This could result in electrical shock.

CAUTION:

1. Office Pro 36 ONLY: The AC outlet (208/230 VAC Single Phase, 60Hz)

needs to be rated at 30A or higher. Do not share the outlet with any
other instrument or equipment.

2. Office Pro 60 ONLY: The AC outlet (208/230 VAC Single Phase, 60Hz)

needs to be rated at 50A or higher. Do not share the outlet with any
other instrument or equipment.

Note:
1. Make sure the AC outlet is free of dirt, dust, oil, water or any other foreign

matter.

2. The Office Pro 36 is equipped with a UL approved LCDI cord and an approved

NEMA plug configuration (6-30).
The appropriate outlet must be used for this plug type.

3. The Office Pro 60 is equipped with an approved NEMA plug configuration (6-

50).
The appropriate outlet must be used for this plug type.