Integra DLV-100 ユーザーズマニュアル

46

• Is “PC Card Viewer” selected from the Source menu?
• Is the CompactFlash memory card seated in the PC CARD slot completely?
• Are slide data stored in the CompactFlash memory card?
• Have the contents of the CompactFlash memory card been destroyed?

• While an image with over 1024

768 dots is projected, several lines of information will be lost.

• Use a computer, etc., to repair the data.

For more information contact your dealer.

No picture

Part of a slide is not displayed

Contents of CompactFlash Card
are damaged

Does not turn on

No picture

Image isn’t square to the screen

Picture is blurred

Image is scrolling vertically, hori-
zontally or both

Remote control does not work

Status indicator is lit or blinking

Cross color in RGB mode

• Check that the power cable is plugged in and that the power button on the projector cabinet or the

remote control is on.

• Ensure that the lamp cover is installed correctly. See page 44.
• Check to see if the projector has overheated or the lamp usage exceeds 1100 hours (up to 1600 hours

: Normal mode). If there is insufficient ventilation around the projector or if the room where you’re
presenting is particularly warm, move the projector to a cooler location.

• Use the menu to select your source (Video, S-Video, RGB or PC Card Viewer). See page 31.
• Ensure your cables are connected properly.
• Use menus to adjust the brightness and contrast. See page 31.
• Remove the lens cap.
• Reset the settings or adjustments to factory preset levels using the Factory Default in the Adjustment

Menu. See page 33.

• Reposition the projector to improve its angle to the screen. See page 23.
• Use the Keystone in the Adjustment Menu to correct the trapezoid distortion. See page 32.

• Adjust the focus. See page 23.
• Reposition the projector to improve its angle to the screen. See page 23.
• Ensure that the distance between the projector and screen is within the adjustment range of the lens.

See page 14.

• Use menus or Source button on the remote control or the cabinet to select the source you want to input.

• Install new batteries. See page 13.
• Make sure there are no obstacles between you and the projector.
• Stand within 22 feet (7 m) of the projector. See page 13.

• See the Status Light messages above.

• If Auto Adjust is off, turn it on. If Auto Adjust is on, turn it off and balance the image with the Position/

Clock in the Image Options. See page 33 or 36.