KVH Industries TracVision R5 ユーザーズマニュアル
11. (Standard Installation) When the antenna unit is
installed with the connectors facing the rear of the
vehicle, the drain holes are located as shown in
Figure 2-5.
vehicle, the drain holes are located as shown in
Figure 2-5.
Figure 2-5 (Standard Installation) Baseplate Connectors Facing
Rear of Vehicle - Factory-drilled Drain Holes
(Alternate Installation) If the antenna unit is
installed with the connectors facing the front of the
vehicle, you MUST drill out
installed with the connectors facing the front of the
vehicle, you MUST drill out
3
⁄
16
" (5 mm)-drain holes
in the rear-facing side of the baseplate (see
Figure 2-6). Then plug the existing factory-drilled
drain holes with silicone sealant (shown in Figure
2-5).
Figure 2-6). Then plug the existing factory-drilled
drain holes with silicone sealant (shown in Figure
2-5).
Figure 2-6 (Alternate Installation) Baseplate Connectors Facing
Front of Vehicle - Recommended Drain Holes
2-6
A Guide to TracVision R5/R4
(Alternate Installation Only) You
MUST drill out the drain holes as
indicated to ensure that any
moisture that enters the baseplate
is able to drain. Ensure that factory-
drilled holes are completely sealed.
MUST drill out the drain holes as
indicated to ensure that any
moisture that enters the baseplate
is able to drain. Ensure that factory-
drilled holes are completely sealed.
Factory-drilled
Drain Hole Positions
Front of
Vehicle
Recommended
3/16" (5 mm)
Drain Hole Positions
Drain Hole Angle
(relative to baseplate)
Front of
Vehicle
Angle of Hole, relative to front
Angle of Hole, relative to front