Viewsonic PJ1165 ユーザーズマニュアル

Before requesting repair, please check in accordance with the following chart. If the 

situation cannot be corrected, please contact your dealer or service company.
NOTE

• Although bright spots or dark spots may appear on the screen, this is a unique 

characteristic of liquid crystal displays, and such do not constitute or imply a machine 

defect.

(This table is continued to the following page.)

 

Never use the projector if abnormal operations such as smoke, strange odor, excessive 

sound, damaged casing or elements or cables, penetration of liquid or foreign matter, etc. 

should occur. In such cases, immediately turn off the power switch and then disconnect 

the power plug from the power outlet After making sure that the smoke or odor has 

stopped, contact your dealer or service company.

Phenomenon

Cases not involving a machine defect

Reference 

page(s)

Power does not 
come on

Correctly connect the power cord.

11

Set the power switch to [ | ] (On).

15

Please turn the power off, and allow the unit to cool down at 
least 20 minutes. After the projector has sufficiently cooled 
down, please turn the power on again.

15

Please turn the power off, and allow the unit to cool down at 
least 45 minutes. After the projector has sufficiently cooled 
down, please make confirmation of the attachment state of the 
lamp and lamp cover, and then turn the power on again.

35, 36

Neither sounds 
nor pictures are 
outputted.

Correctly connect the connection cables.

8, 9

Correctly set up the signal source device by referring to the 
manual of the source device.

-

Select the input signal, and correct the settings.

16