GE wpgt9360 ユーザーズマニュアル

Problem Solver

Control panel is asleep

• This is normal. Press POWER, the Touch Screen

or any button to activate the control panel.

Washer is unplugged

• Make sure cord is plugged securely into a working outlet.

Water supply is turned off

• Turn both hot and cold faucets fully on.

Controls are not set properly

• Make sure the cycle was set correctly, close the lid and 

press START.

Lid is open—safety feature.

• Close lid and reset cycle, to the beginning if necessary.

Prevents the washer from filling
and operating when lid is up

Circuit breaker/fuse is

• Check house circuit breakers/fuses. Replace fuses or 

tripped/blown

reset breaker. Washer should have separate outlet.

Electronics need to be reset

• Unplug washer, wait 2 minutes, plug back in and press 

.

was not pressed after a 

• Press START.

cycle was set

Extremely low water pressure

• Press START again.

Washer is too cold

• If the washer has been exposed to temperatures below 

freezing for an extended period of time, allow it to warm 
up before pressing POWER. Otherwise, the display will 
not come on.

Filter clogged or fill hoses may

• Make sure that the water valve filters (blue and orange 

be kinked

screen must be free of solids) on the unit are not 
clogged. Turn off water and check filter by disconnecting 
hose at machine. Check that fill hoses are not kinked 
or clogged.

Energy efficiency

• This is an energy efficient washer. As a result, the 

temperature settings for this washer may be different 
than non-energy efficient washers.

Insufficient water supply

• Make sure that the water supply is turned on. Make sure 

that the water faucets are turned to their completely 
open positions.

The washer lid is open

• The washer lid must be closed for all washer cycle 

operations. If the lid is opened during washer 
operation, all functions will stop, including water filling.

Incorrect fill hose connection

• Make sure that the fill hoses connect the hot water 

supply to the hot inlet on the washer, and the cold water 
supply to the cold inlet on the washer (hot to hot, cold 
to cold).

Water fill optimization

• Water may not cover the top level of the clothes. This is 

normal for this high efficiency washer. The water fill is 
optimized by the system for best wash performance.

For a complete list of solutions to common washer problems, use the
Troubleshooting Tips feature located by pressing the HELP button 
while on the washer Home Screen (see Using the Troubleshooter).

29