Hitachi VM-H71A ユーザーズマニュアル

ページ / 69
Before You Begin 
 
14
accessories, please see the optional accessory listing found on page 65. 
WATER-RESISTANT 
Water-Resistant Structure 
Your camera/recorder uses three packings as shown below to provide a 
water-resistant structure. 
Case 
 
 To Check the Packing 
 
1. Open the case so the end of the bracket is positioned as shown in the 
figure and pull the bracket forward to release it. 
2. After checking, replace the bracket to its original position. 
 
CAUTION 
 How to Handle the Water-resistant Packings 
 Inspect the water-resistant packings constantly to check that there are no 
scratches or chipping as they could cause water to enter. 
 Check that no foreign matter adheres to the water-resistant packings before 
closing the cases. If the camera/recorder is used while dust, sand, or thread 
adheres to only one point if the packings, it could cause water to enter. 
 Consult your nearest dealer to replace the packings. 
 The Camera/Recorder cannot be used in the following places 
 Under water 
 In a place with high temperature and high humidity such as in a sauna, 
bathroom, etc. 
 Where water would strike it violently (where water pressure is applied) 
Note: The camera/recorder cannot be used under water because it is not 
water-proof. 
 Be Careful when Opening and Closing the Sections with Packing 
 The camera/recorder inside the case is not structured to be water-resistant. 
Take great care that no water droplets enter inside. 
 Check that the three sections with packing are closed tightly to ensure that 
it is water-resistant.