GTO pro f3100 intercomkeypad ユーザーズマニュアル
Crystal clear two-way communication up to 500 feet wireless or 1000 feet wired.
Wireless Gate Entry Intercom/Keypad
Thank you for purchasing the GTO Wireless Gate Entry Intercom/Keypad. Be sure to read the
directions carefully and completely. Before permanently mounting the intercom/keypad, please
program the keypad and test its range.
directions carefully and completely. Before permanently mounting the intercom/keypad, please
program the keypad and test its range.
IMPORTANT: Your intercom/keypad may need to be hard wired due to the fact that it must
accept interference according to FCC regulations listed below. For example, applications that
are relativity close to cell towers or airports may receive intermittent interference and require
hard-wiring.
accept interference according to FCC regulations listed below. For example, applications that
are relativity close to cell towers or airports may receive intermittent interference and require
hard-wiring.
In areas of high radio frequency (RF) interference, the keypad may need to be connected (hard
wired) directly to the gate opener using 16 gauge (AWG) stranded, direct burial, low voltage
wire (part no. RB509 not included).
wired) directly to the gate opener using 16 gauge (AWG) stranded, direct burial, low voltage
wire (part no. RB509 not included).
Also in areas of high radio frequency (RF) interference, the intercom base unit may need to be
hard wired to the keypad using co-ax (cable TV cable not included) .
hard wired to the keypad using co-ax (cable TV cable not included) .
Instructions for Wireless and Wired Installations
GTO, Inc. • 3121 Hartsfield Road • Tallahassee, Florida 32303
Telephone (850) 575-0176 • Fax (850) 575-8912 • website www.gtoinc.com
SAFETY NOTE: Never install the keypad portion of this unit where a person
can reach through the gate to activate it, or where a person can touch the gate
while activating the keypad. The recommended minimum distance between the
gate and keypad is 10 ft.
can reach through the gate to activate it, or where a person can touch the gate
while activating the keypad. The recommended minimum distance between the
gate and keypad is 10 ft.
©2005 GTO, Inc.
rev - 06-17-05
IMPORTANT:
Allow the
intercom base unit’s battery
to charge for 12 hours before
using the system for the first
time. See page 6 for details.
to charge for 12 hours before
using the system for the first
time. See page 6 for details.