Hitachi VM-E56A ユーザーズマニュアル

ページ / 64
General Maintenance 
 
 
 
   
pg. 
51
 
- 54 - 
 
54
Troubleshooting 
Quality is very important at Hitachi. We inspect and check every camera/recorder carefully at the factory under the 
most rigid quality control and inspection systems. If problems develop please check the following possible 
solutions before inquiring about professional service. 
INSERTING OR REMOVING THE CASSETTE 
SYMPTOM 
CHECK POINT & CORRECTION 
Cassette holder cannot be opened when you push 
EJECT switch. 
Connect the power source. 
Cassette cannot be inserted into cassette 
compartment. 
Load cassette in direction indicated by arrow on 
cassette. 
 
Cassette window must be toward outside. 
 
CAMERA RECORDING 
SYMPTOM 
CHECK POINT & CORRECTION 
Picture does not appear  in the viewfinder. 
Remove the lens capl 
 
Slide the CAMERA/OFF/VIDEO switch to 
CAMERA. 
 
Disconnect the AV input cable from the 
camera/recorder. 
The camera/recorder cannot go into the recording 
mode, even when the start/stop button is pressed. 
Check the record-protect tab on the cassette.  
 
Push the cassette holder embossed PUSH to close it. 
Picture is out of focus. 
Make sure that FOCUS does not appear in the 
viewfinder. 
Auto-focus does not operate. 
If it is displayed, press FOCU Control 
(AUTO/MAN) buttons to erase it. 
 
Auto-Focus does not operate if a special effects filter 
is attached or the objects shown on page 33 are 
being recorder/ 
 
 
RECORDING TV PROGRAMS OFF THE AIR 
SYMPTOM 
CHECK POINT & CORRECTION 
The camera/recorder cannot be set to the recording 
mode, even when the Start/Stop button on the 
camera/recorder is pressed. 
Check the record protect tab on thecassette. 
 
Set the CAMERA/OFF/VIDEO switch to camera. 
 
Connect the camera/recorder and TV or VCR. 
PLAYBACK OF PRE-RECORDED CASSETTE 
SYMPTOM 
CHECK POINT & CORRECTION 
PLAY button cannot be engaged. 
Set the CAMERA/OFF/VIDEO switch to 
VIDEO. 
No picture appears on television screen when 
PLAY is pressed. 
Set the television to the camera/recorder 
channel (3 or 4).   
Interference on playback picture. 
When you see the playback picture on your TV, 
adjust fine tuning knob by using RF output on 
television set to obtain best picture.