Olympus evolt e-500 ユーザーズマニュアル
24
En
Shooting
Set the mode dial to
AUTO.
1
Place the AF frame on the subject while
viewing through the viewfinder.
viewing through the viewfinder.
2
Adjust the focus.
Press the shutter button gently (halfway).
• The focus is locked. The AF
• The focus is locked. The AF
confirmation mark and the AF focusing
frame light up in the viewfinder.
frame light up in the viewfinder.
• The shutter speed and aperture value
that have been set automatically by the
camera are displayed.
camera are displayed.
• The control panel screen is not
displayed when the shutter button is
pressed.
pressed.
• When you use the camera in the dark,
the flash pops up automatically if the
camera is set to
camera is set to
AUTO
.
3
Release the shutter.
Press the shutter button all the way (fully).
• When a picture is taken, a shutter sound is output.
• The card access lamp blinks and the camera starts recording the picture.
• After 1 minute* without any operation being performed, the monitor turns off
• When a picture is taken, a shutter sound is output.
• The card access lamp blinks and the camera starts recording the picture.
• After 1 minute* without any operation being performed, the monitor turns off
and the camera stops operating. To wake up the camera, simply press any
button, e.g. the shutter button. After about 4 hours* without being used, the
camera will turn off automatically. Turn on the camera again.
button, e.g. the shutter button. After about 4 hours* without being used, the
camera will turn off automatically. Turn on the camera again.
* Factory default settings. You can change the time settings using the custom
menu.
Shutter button
Card access lamp
AF frame
Viewfinder
Halfway down
AF confirmation mark
All the way down
s0004_oe_Basic.book Page 24 Friday, September 16, 2005 6:51 PM