ICOM id-rp2 ユーザーズマニュアル

42

7

REPEATER SETTINGS

■ Frequency setting for ID-RP2V

q Start up the PC.
w Connect an USB cable 

(A-B type; purchase sepa-

rately)

between PC’s USB port and ID-RP2V [SER-

VICE] connector, then turn the ID-RP2V power ON.

• Connect an USB cable to [SERVICE R] when setting re-

ceive frequency.

• Connect an USB cable to [SERVICE T] when setting

transmit frequency.

e Start up the ID-RP2V/D utility.

Double click the “ID-RP2VD” icon on the desktop or
select the “ID-RP2VD” in “Program” in “Start” menu.

r The screen as at left appears, then the dialog below

is displayed.

• Click [OK].

NOTE: The screen, described in steps t, ap-
pears instead of these screens when the correct
COM port number is set.

• Click <Option (O)> menu then select <COM Port(P)…>.

Enter the allocated number of the ID-RP2V [SERVICE]
connector then click [Apply] in the displayed “COM Port
Setting” screen.

NOTE: See pages 31 and 32 for the COM port
number confirmation details.

t The utility reads the ID-RP2V setting and the screen

as at left appears when the correct COM port num-
ber is set.

y Enter the specified receive and transmit frequencies

into “RX/TX Frequency” column.

u Click [Write] to program the set frequencies into the

ID-RP2V.

w Click

q Enter the speci-

fied frequency.

Enter the COM port number.

Click

NOTE: 
The repeater unit connection may not be recognized
with the PC according to the using USB cable length.
Use the shorter USB cable as possible is recom-
mended.