Human Touch ht-130 ユーザーズマニュアル
REMOVING THE BACKREST
1. Locate the connector box on the bottom left-hand side of the chair (Fig.2).
2. Using your fingers, pop open the connector box cover, remove the cover, then disconnect the connectors.
3. Locate the connector box on the bottom right-hand side of the chair (Fig.3).
4. Using a Phillips-head screwdriver, remove the two screws that secure the connector box cover, remove the cover, then disconnect both connectors.
5. Using a nail clippers, or other suitable instrument, cut and remove all zip ties that secure the two backrest connectors and cables to the bottom of the
2. Using your fingers, pop open the connector box cover, remove the cover, then disconnect the connectors.
3. Locate the connector box on the bottom right-hand side of the chair (Fig.3).
4. Using a Phillips-head screwdriver, remove the two screws that secure the connector box cover, remove the cover, then disconnect both connectors.
5. Using a nail clippers, or other suitable instrument, cut and remove all zip ties that secure the two backrest connectors and cables to the bottom of the
chair, being careful not to cut the wire casing.
Tools Required: Pliers, vice grip, Phillips-head screwdriver, small hammer, nail clipper or other instrument suitable for cutting zip ties, new zip ties
NOTE: This procedure can be completed by one person, although having a second person is helpful when
NOTE: This procedure can be completed by one person, although having a second person is helpful when
installing the new backrest. SAVE ALL PARTS FOR USE DURING REASSEMBLY.
1. Remove the head pillow and backrest pad, following the instructions in the Use and Care manual.
2. Push down on the backrest release lever, then fold the backrest forward onto the chair seat (Fig.1).
3. Power off the chair and unplug it.
2. Push down on the backrest release lever, then fold the backrest forward onto the chair seat (Fig.1).
3. Power off the chair and unplug it.
GET READY
Connector box
Connector box
(Left-hand side of the chair)
(Right-hand side of the chair)
04/20/09
REPLACING THE BACKREST
HT-130
(Fig.1)
(Fig.2)
(Fig.3)
1
Backrest release lever
To ensure that Human Touch
®
products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL: 3