Olympus camedia c-5050 ユーザーズマニュアル

ページ / 2
1
Set the mode dial to 
 and turn the power 
switch so that ON is aligned with the white 
line.
2
Position the AF target mark in the 
viewfinder on the subject.
3
Press the shutter button gently (halfway) to adjust the 
focus.
• When the focus and exposure are locked, the green lamp lights.
• If the orange lamp lights, the flash fires automatically.
4
Press the shutter button all the way (fully).
• The camera takes the picture.
• The card access lamp blinks while the picture is stored on the 
card.
• When the green lamp stops blinking, you can take the next 
picture.
 To turn off the camera
Turn the power switch so that OFF is aligned with the white line.
1
Set the mode dial to 
 and turn the power 
switch so that ON is aligned with the white 
line.
• The monitor turns on and displays the last picture 
taken. (Single-frame playback)
2
Use the arrow pad or jog dial to play back other pictures.
1
Set the mode dial to 
 and turn the power switch so that ON is aligned 
with the white line.
• The monitor turns on and the available recording time on the card that you are using 
is displayed. 
2
Decide the composition while looking at the image on the monitor.
3
Press the shutter button fully to start recording.
• The orange lamp on the right of the viewfinder lights.
• During movie recording, 
 lights red.
4
Press the shutter button again to stop recording.
1
Set the mode dial to 
 and turn the power switch so that ON is aligned 
with the white line.
• The monitor turns on.
2
Use the arrow pad or jog dial to display the picture with 
 you want to 
play back.
3
Press .
• The top menu is displayed.
4
Press 
 to select MOVIE PLAY.
5
Press 
 to select MOVIE PLAYBACK, then 
press .
• The movie is played back. When playback ends, the 
display automatically returns to the beginning of the 
movie.
6
Press 
 again after playback ends to display 
the menu.
Press 
 to select the desired operation, then press 
.
PLAYBACK
: Plays back the entire movie again.
FRAME BY FRAME : Plays back the movie manually one frame at a time.
EXIT
: Leaves the movie playback mode.
You are recommended to protect important pictures to avoid accidentally erasing 
them.
1
Use the arrow pad or jog dial to display 
the picture you want to protect.
 “Viewing still pictures”
2
Press .
• The 
 mark appears on protected 
pictures.
• To cancel protection, press 
 again.
1
Use the arrow pad or jog dial to display 
the picture you want to erase.
 “Viewing still pictures”
2
Press .
• The 
 ERASE screen is displayed.
3
Press 
 to select YES, then press 
.
• The picture is erased and the menu is closed.
Taking still pictures
Mode dial
Power switch
Orange 
lamp
Green 
lamp
AF target mark
Viewing still pictures
Mode dial
Power switch
Pictures can be played back by pressing 
 twice quickly (double-click) even 
when the mode dial is set to a mode other 
than .
Quick View
Displays the next 
picture.
Displays the previous 
picture.
Jumps to the picture 10 frames back.
Jumps to the picture 10 frames ahead.
 Arrow pad
Displays the next 
picture.
Displays the previous 
picture.
 Jog dial
Recording movies
Viewing movies
MOVIE PLAY
INFO
MODE MENU
Protecting pictures
Erasing pictures (Single-frame erase)
Protect button
Erase button
YES
NO
SELECt
GO
ERASE
We’ve included this convenient Quick start guide to show you basic functions and 
techniques that will help you quickly master your new camera. For more detailed 
descriptions of procedures, as well as for additional information on more sophisticated 
features not covered here, please refer to the printed “Basic Manual”, or the primary 
“Reference Manual” on the CD-ROM.
1
Pass the lens cap string through the hole in 
the lens cap.
2
Fasten the strap to the strap eyelet as shown 
in the diagram.
3
Adjust the strap to the desired length. Pull 
the strap through the stopper (
) and make 
sure it is fastened securely.
4
Attach the strap to the other eyelet in the same way.
When you want to take pictures, be sure to remove the 
lens cap before turning on the camera.
1
Make sure the power switch is set to OFF.
2
Slide the battery compartment lock from 
 to 
.
3
Place your finger on the
mark and slide the 
battery compartment cover in the direction of 
then lift in the direction of 
.
• Use the ball of your finger to slide the cover. Do not use 
your fingernail as this could result in injury.
4
Insert the batteries, making sure that they are correctly oriented as shown 
in the illustration.
5
Close the battery compartment cover, 
then press it down 
 and slide it in the 
direction shown 
.
• Press the center of the cover, as it may be difficult to 
close properly by pressing the edge.
• Make sure the cover is closed securely.
6
Slide the battery compartment lock from 
 to 
.
1
Make sure the power switch is set to OFF.
2
Open the card cover.
3
Insert a card.
• Hold the card straight and insert it correctly into the xD-Picture 
Card/SmartMedia slot, as shown.
• An illustration showing the position for inserting the xD-Picture 
Card is next to the slot.
4
Close the card cover securely until it clicks.
 Ejecting the card
1
Push the card all the way in to unlock it, then let it return 
slowly. 
The card is ejected a short way and then stops. Hold the 
card straight and pull it out.
• The xD-Picture Card and SmartMedia use the same slot, as do Compact Flash and 
Microdrive. Two cards cannot be inserted in the one slot at the same time.
Never open the card cover, or remove the card or the batteries while the 
camera is turned on. Doing so could destroy the data stored on the card. 
Once destroyed, data cannot be restored.
Package contents
Quick start guide
C-5050ZOOM
DIGITAL CAMERA
 
Camera
 
Strap
 
Lens cap/String
 
NiMH batteries (rechargeable)/ 
Battery charger/instruction (Olympus 
America and Olympus Europa only)
 
USB cable
 
AV cable
 
Basic manual
;
Quick start guide
 
Software installation guide (included in 
the CD-ROM package)
 
CD-ROM with Windows 98 USB driver 
software, Reference manual, and more.
 
Warranty card/Registration card (not 
provided in some areas)
 
Safety Precautions (booklet)
 
xD-Picture Card
 
xD-Picture Card instructions
 
Remote control (Olympus America only)
 
Remote control instruction (Olympus 
America only)
OLYMPUS AMERICA INC.
Two Corporate Center Drive, Melville, NY 11747-3157, U.S.A. Tel. 631-844-5000
24/7 online automated help: http://support.olympusamerica.com/
Phone customer support: Tel. 1-888-553-4448 (Toll-free)
Our phone customer support is available from 8 am to 10 pm (Monday to Friday) ET
E-Mail: distec@olympus.com
Olympus software updates can be obtained at: http://olympus.com/digital/
OLYMPUS OPTICAL CO. (EUROPA) GMBH.
Premises/Goods delivery:  Wendenstrasse 14-18, 20097 Hamburg, Germany
Tel. 040-237730
Letters: Postfach 10 49 08, 20034 Hamburg, Germany
http://www.olympus.com/
Printed in Japan
1AG6P1P1441--
VT406901
1. Attaching the strap and lens cap
2. Taking off the lens cap
Strap eyelet
3. Loading the batteries
When using AA (R6) batteries
When using CR-V3 lithium battery packs
Battery 
alignment
The correct way to insert the AA batteries 
is indicated on the bottom of the camera.
4. Inserting an xD-Picture Card
Releasing your finger quickly after pushing the 
card all the way in may cause it to eject forcefully 
out of the slot.
 Note
Note
qsge_pquick.fm  Page 1  Tuesday, September 17, 2002  1:43 PM