OKI network 7120e ユーザーズマニュアル

OkiLAN 7120e Network User’s Guide

69

Computer cannot find the network interface card.

Turn the printer off and on again.
Confirm the network interface is enabled on the printer.
Check the network cable is correctly connected. The green LED near the 
network interface should be lit. Otherwise, change the cable and try again.
Check there is a response to the 

 command.

Run the Self-diagnostic test. 
Check the IP Address, Subnet Mask and Gateway are correct. 
Check that the TCP/IP protocol is set to 

.

Reset the network interface card to factory default settings.
If DHCP, BOOTP and RARP are not used, ensure they have been set to 

.

Cannot print with lpr and ftp.
Turn the printer off and on again.
Check there is a response to the 

 command.

Check the network cable is correctly connected. 
Change the cable and try again.
Check the host name and IP address are configured in the workstation.
Check the printer port name is configured in the workstation.
There are three port names: 

, 

 and

. Use 

 by default as 

and 

are specific to PostScript printers. 

Incorrect User name on the banner page.

If printing with lpr, the User name printed is 

 and the Filename 

printed is the Spool file name.
If printing with FTP, the User name printed is the User name entered 
during FTP login and the File name printed is the Transmitted file name. If 
the Print Directory name is indicated in the 

 command, the File name 

is not printed. The Printer name printed is the Logical Directory name.

Computer cannot find the network interface card.

Turn the printer off and on again.
Confirm the network interface is enabled on the printer.