Moog mf105b ユーザーズマニュアル
TECHNICAL INFORMATION
NOTE: The following information is intended for use by people who understand analog
electronic circuitry and have enough practical experience to interconnect sophisticated
electronic equipment correctly.
electronic circuitry and have enough practical experience to interconnect sophisticated
electronic equipment correctly.
X-FACTOR
This setup shows off how
long envelope times, in
relation to the pattern’s
rate, creates a morphing
timbre. Try increasing
the rate on this setup to
make for a more tremu-
lous effect.
long envelope times, in
relation to the pattern’s
rate, creates a morphing
timbre. Try increasing
the rate on this setup to
make for a more tremu-
lous effect.
Figure 13 – Correct wiring of power supply
connector
POWER: The MF-105B works
on +9 volts DC and uses a max
of about 240 milliamperes of
current.
on +9 volts DC and uses a max
of about 240 milliamperes of
current.
Use only the power
supply supplied with the MF-
105B or the exact equivalent.
Power sources rated with
voltages in excess of +9 volts
may cause damage to the MF-
105B’s circuit.
PEDAL INPUTS: All pedal control input jacks are 1/4” tip-ring-
sleeve (stereo) phone jacks. The sleeves are grounded and the ring
terminals are supplied with +5 volts which is current-limited. The
tip terminals receive the variable voltages from the pedals.
sleeve (stereo) phone jacks. The sleeves are grounded and the ring
terminals are supplied with +5 volts which is current-limited. The
tip terminals receive the variable voltages from the pedals.