Moog mf105b ユーザーズマニュアル
GETTING STARTED
Here are some simple instructions on how to quickly plug in and
try out your MF-105B.
try out your MF-105B.
1. Unpack your MF-105B. Place it on a table while you become
familiar with its features.
familiar with its features.
2. Check that the power adaptor has a nominal rating of +9 volts,
providing at least 300 mA (milliamperes) of current and is also
rated at your country’s standard power voltage (120 volts A.C.
for the United States and Canada; 100 volts A.C. for Japan; and
220 volts A.C. for most other countries). Plug the power adaptor’s
cord into the MF-105B’s ‘+9V’ jack. Then plug the power adaptor
itself into a power voltage receptacle.
providing at least 300 mA (milliamperes) of current and is also
rated at your country’s standard power voltage (120 volts A.C.
for the United States and Canada; 100 volts A.C. for Japan; and
220 volts A.C. for most other countries). Plug the power adaptor’s
cord into the MF-105B’s ‘+9V’ jack. Then plug the power adaptor
itself into a power voltage receptacle.
Note the Bass MuRF
uses a different power supply than some other Moogerfooger
effect modules, which are only rated at 200mA. Using a 200mA
power supply may result in hum, distortion, and other less than
desirable audio artifacts. Make sure to use the proper power
supply.
3. Note that the BYPASS light is on. It will light up either red
or green. Red indicates the
MF-105B’s effect is off-
line (bypassed), while green
indicates the effect is on.
Pressing the ‘stomp switch’
will toggle the BYPASS light
between red and green. For
now, leave the BYPASS light
on red.
MF-105B’s effect is off-
line (bypassed), while green
indicates the effect is on.
Pressing the ‘stomp switch’
will toggle the BYPASS light
between red and green. For
now, leave the BYPASS light
on red.
Refer to Figure 1 for steps 4.
and 5.
and 5.
Figure 1 - Basic Connections to Bass MuRF