Havis-Shields c-3089's ユーザーズマニュアル

 

 

TOOLS NEEDED: 
Ratcheting wrench 
Standard socket set 
Open-end wrench set 

Allen wrench set 
Screwdriver set

 Read all instructions before installing any Havis-Shields Equipment Corp products. 
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! 
 Use hardware provided with install kit 
 For product support, visit the Install Instructions Section of our website at 

http://havis.com/Installation/Installation.html

 

 

•  Photo #3 on page #2 is a basic assembly 

instruction of a C-3090-3 (w/ tilt/swivel) 
mounting to a C-TCB-x. 

•  The tilt/swivel assembly, (Photo #1), which 

comes pre-assembled to the C-3090 from the 
factory, will bolt directly to the rotating plate, 
using the hardware loosely attached to the 
plate. You do not need to unassembled the 
tilt/swivel from the C-3090. 

Note: Be sure the 2” fender washer is assembled between 
the rotating plate and the tilt/swivel assembly.  
 

•  The C-3090 will come pre-assembled with 

tilt/swivel attached.  

•  Mount trak kit into vehicle.  
•  Place console and C-3090 into desired 

position on trak. (Photo #2)  

 

•  Slide ¼-20 hex nuts into slots on side of trak 

in location to mount C-3090. 

•  Attach C-3090 to trak using ¼-20 x ½” hex 

bolts and washers. Tighten in desired area.