honda-automobiles bfp9.9d ユーザーズマニュアル
−
35
BATTERY CONNECTIONS
TRANSOM ANGLE
ADJUSTMENT
ADJUSTMENT
(models without clamp screws)
INSTALLATION
TO ACCESSORIES
BATTERY
LOCK NUT
WASHER
BOLT
LOCK NUT
TRANSOM
BOARD
BOARD
WASHER
MOUNTING
HOLE
HOLE
WASHER
Honda BF8D/BFP8D/BF9.9D/
BFP9.9D/BF15D/BFP15D/BF20D
and BFP20D outboard motors
produce a 12-volt, 6 or 12-ampere
battery-charging current and are
equipped for connection to a 12-volt
battery. The battery-charging circuit
is protected by a 20-ampere fuse
located in the engine compartment.
BFP9.9D/BF15D/BFP15D/BF20D
and BFP20D outboard motors
produce a 12-volt, 6 or 12-ampere
battery-charging current and are
equipped for connection to a 12-volt
battery. The battery-charging circuit
is protected by a 20-ampere fuse
located in the engine compartment.
The outboard motor’s 12-volt output
is intended for battery charging only.
Lights and electrical accessories for
the boat should be connected to the
battery.
is intended for battery charging only.
Lights and electrical accessories for
the boat should be connected to the
battery.
Use the transom angle adjustment rod
(p.
(p.
) to adjust the angle of the
outboard motor so the propeller is
perpendicular to the surface of the
water.
perpendicular to the surface of the
water.
Attach the stern bracket to the boat
transom with good quality stainless
steel bolts, nuts, and washers. Apply
silicone sealant to the bolt holes.
transom with good quality stainless
steel bolts, nuts, and washers. Apply
silicone sealant to the bolt holes.
04/03/15 10:27:35 31ZY0600_036