Hyundai a2054-326 ユーザーズマニュアル

 

 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 

Your car and the engine bay should look like the ones 
in these pictures, if not then talk to your kit supplier. 
Should you still have a problem, call K&N customer 
services.  Tel: 01925-629609.  Fax: 01925-629610. 

1. Unclip and remove 
the intake hose from 
the MAS (Mass Air 
Sensor). 

2. Unclip and remove 
the air box lid 
assembly and filter 
element from the air 
box base. 

3. Remove the air box 
base from the inner 
wing by removing the 
3 securing screws 
located inside of the 
air box base. 

1. Fit the new filter onto 
the MAS. Tighten the 
clip until the filter just 
turns, Rotate the filter 
until the K&N logo is 
straight then tighten the 
clip one full turn (360 
degrees) no more, Do 
not overtighten the 
clip. 

2. Attach the new 
bracket to the rear air 
box mounting point 
located on the inner 
wing using an original 
mounting screw. 

3. Attach the stud on 
the filter lid to the 
bracket using a nut, flat 
washer and spring 
washer supplied. 

4. Carefully lengthen 
the flexi cold air hose 
to approx. 76cm / 30” 
and feed it down past 
the side of the radiator 
to the front lower grille.

5. Pierce a hole in the 
top of the flexi cold air 
hose and attach the 
hose to the middle air 
box mounting point 
using a plastic tie 
supplied. Position the 
end of the flexi cold air 
hose to finish 10cm / 
4” from the filter no 
nearer.