Chamberlain WD962KPEV ユーザーズマニュアル
20
Connect the door arm to the trolley
9
Option B
SECTIONAL DOORS
H20
H21
H15
9.1B
Close the door. Disconnect the
trolley by pulling the emergency
release handle.
trolley by pulling the emergency
release handle.
9.2B
Attach the straight door arm to
the outer trolley using the clevis
pin (H14). Attach with the ring
fastener (H19).
the outer trolley using the clevis
pin (H14). Attach with the ring
fastener (H19).
H19
H14
9.3B
Attach the curved door arm to
the door bracket using the clevis
pin (H13). Attach with the ring
fastener (H19).
the door bracket using the clevis
pin (H13). Attach with the ring
fastener (H19).
H19
H13
9.4B
Bring arm sections together. Find
two pairs of holes that line up and
join sections. Select holes as far
apart as possible to increase door
arm rigidity and attach using the
bolts (H15), nuts (H20) and lock
washers (H21).
two pairs of holes that line up and
join sections. Select holes as far
apart as possible to increase door
arm rigidity and attach using the
bolts (H15), nuts (H20) and lock
washers (H21).
H20
H21
H15
Tip:
If the holes in the curved door arm and the straight door arm do not align, reverse the
straight door arm, select two holes (as far apart as possible) and attach using bolts (H15),
nuts (H20), and lock washers (H21).
nuts (H20), and lock washers (H21).
If the straight door arm is
hanging down too far, you
may cut 6 inches (15 cm)
from the solid end.
hanging down too far, you
may cut 6 inches (15 cm)
from the solid end.
9.5B
Pull the emergency release handle toward the garage door opener until the trolley
release arm is horizontal. The trolley will re-engage automatically when the garage
door opener is activated.
release arm is horizontal. The trolley will re-engage automatically when the garage
door opener is activated.
Trolley
release arm
release arm
Installation