Chamberlain WD962KPEV ユーザーズマニュアル

35

Your garage door opener is equipped with features to provide you with greater control over 
your garage door operation.
 

The Timer-to-Close feature automatically closes the door after a specifi ed time period that 
can be adjusted using the door control. Prior to the door closing there will be an audible and 
visual alert.

MYQ™

MyQ™ technology uses a 900MHz signal to provide two-way communication between the 
garage door opener and MyQ™ accessories. Your garage door opener is compatible with up 
to 8 MyQ™ accessories.

SECURITY✚

 

Your garage door opener is compatible with up to 2 Security✚

 

2.0™ door controls.

Your garage door opener has already been programmed at the factory to operate with your 
remote control, which changes with each use, randomly accessing over 100 billion new 
codes. The garage door opener is compatible with up to 8 remote controls and 1 keyless 
entry. 

When properly connected and aligned, the safety reversing sensors will detect an obstruction 
in the path of the infrared beam. If an obstruction breaks the infrared beam while the door is 
closing, the door will stop and reverse to full open position, and the opener lights will fl ash 
10 times. If the door is fully open, and the safety reversing sensors are not installed, or are 
misaligned, the door will not close from a remote control. However, you can close the door 
if you hold the button on the door control or keyless entry until the door is fully closed. The 
safety reversing sensors do no effect the opening cycle.

For energy effi ciency the garage door opener will enter sleep mode when the door is fully 
closed. The sleep mode shuts the garage door opener down until activated. The sleep mode 
is sequenced with the garage door opener light bulb; as the light bulb turns off the sensor 
LEDs will turn off and whenever the garage door opener lights turn on the sensor LEDs will 
light. The garage door opener will not go into the sleep mode until the garage door opener 
has completed 5 cycles upon power up.

The garage door opener light bulbs will turn on when the opener is initially plugged in; power 
is restored after interruption, or when the garage door opener is activated. The lights will turn 
off automatically after 4-1/2 minutes. An incandescent A19 light bulb (100 watt maximum) 
or for maximum energy effi ciency a 26W (100W equivalent) compact fl uorescent light (CFL) 
bulb may be used.

The garage door opener is equipped with an added feature; the lights will turn on when 
someone enters through the open garage door and the safety reversing sensor infrared beam 
is broken. For added control over the light bulbs on your garage door opener, see the Door 
Control section.

The garage door opener can be activated through a wall-mounted door control, remote 
control, wireless keyless entry or MyQ™ accessory. 

When the door is closed and the garage door opener is activated the door will open. If the 
door senses an obstruction or is interrupted while opening the door will stop. When the door 
is in any position other than closed and the garage door opener is activated the door will 
close. If the garage door opener senses an obstruction while closing, the door will reverse. If 
the obstruction interrupts the sensor beam the garage door opener lights will blink 10 times. 
However, you can close the door if you hold the button on the door control or keyless entry 
until the door is fully closed. The safety reversing sensors do no effect the opening cycle.

The safety reversing sensor must be connected and aligned correctly before the garage door 
opener will move in the down direction.