Chamberlain WD962KPEV ユーザーズマニュアル

9

Pull the belt around the pulley and 
toward the trolley. The ribbed side 
must contact the pulley.

Hook the trolley connector into the 
retaining slot on the trolley as shown.

With the trolley against the 
screwdriver, dispense the remainder of 
the belt along the rail length toward the 
motor unit and around the sprocket. 
The sprocket teeth must engage the 
belt.

Check to make sure the belt is not 
twisted. Connect the trolley threaded 
shaft with the master link (H5).

 

  •   Push pins of master link bar 

through holes in end of belt and 
trolley threaded shaft.

 

  •   Push master link cap over pins and 

past pin notches.

 

  •   Slide clip-on spring over cap and 

onto pin notches until both pins are 
securely locked in place.

Insert the trolley threaded shaft 
through the hole in the trolley.

Master Link

Threaded Shaft

H5

H1

H5