Havis-Shields wgi-c14 ユーザーズマニュアル

 

WGI-C14-INST-1-04

 

INSTALLATION INSTRUCTIONS MODEL WGI-C14 

TOOLS REQUIRED: 
Safety goggles 
Power drill 
 

Phillips screwdriver 
1/8” drill bit 

24 

#10 x ½” Phillips flat head sheet metal screw  

GSM33150 

 

36 

#10 x 3/4” Phillips pan head sheet metal screws 

GSM33195 

 
 
INSTALLATION PROCEDURE: 
1.  Determine the proper cage for each window.  Each guard has part number on lower left corner. 
2.  Side Passenger Door Windows – Hold the screen up to the window frame.  Make sure you have an 

even fit.  Mark mounting holes and drill out with the 1/8” drill bit.  Use #10 x ½” flat head sheet 
metal screws to attach screens to door window frame.  Note:  Do not over tighten screws.  After the 
1/8” holes are drilled, it is helpful to indent the holes inward with a punch.  This will enable the 
mounting screws to grab better. 

3.  Side Cargo Area Windows – Carefully remove interior plastic trim that surrounds windows.  

Position window guard into window frame. (Guard will be approximately ½” from glass).  Drill 
mount holes in window frame with 1/8” drill bit and attach guard with #10 x ¾” sheet metal screws.  
Install interior trim back to original location.   
Note:  Trim should fit back on without modification, although plastic sometimes needs to be shaved 
to allow clips to go on properly. 

4.  Rear Door Windows – These guards are mounted the same way as the side cargo windows.