Omron C200H-LK401 ユーザーズマニュアル
42
Observe the following when soldering wires onto the connector.
1.
Place heat-shrinking tubes onto all wires far enough from the end so as
to not interfere with soldering.
to not interfere with soldering.
2.
Presolder all wires and connector terminals.
3.
Solder all wires, inserting 4 mm of the exposed 5 mm of wire into the
connector terminal.
connector terminal.
4.
Move the heat-shrinking tubes onto the soldered area and shrink them
into place.
into place.
Assemble the connector hood as shown the following diagram. See the con-
nection diagrams above to confirm whether one end is or is not to be con-
nected to the shield wire.
nection diagrams above to confirm whether one end is or is not to be con-
nected to the shield wire.
ÇÇ
ÇÇ
Aluminum foil tape
Hood (FG) connected
to shield wire
to shield wire
Hood (FG) not connected
to shield wire
to shield wire
5-2
Dimensions
Unit: mm
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
ÉÉ
250
100*
Approx.
150**
150**
Backplane
35
Soldering
1, 2, 3...
Hood Assembly
C500-LK009-V1
Dimensions
Section 5-2