Vertex Standard FT-2000 ユーザーズマニュアル
Page 34
FT-2000 O
PERATING
M
ANUAL
Before turning on main power, please verify the following items once more.
Have you made all ground connections securely? See page 9 for details.
Do you have your antenna(s) connected to the rear-panel Antenna jack(s)? See page 10 for details.
Is your microphone (and/or key or paddle) connected? See pages 11 and 12 for details.
Is your microphone (and/or key or paddle) connected? See pages 11 and 12 for details.
If using a linear amplifier, have all interconnections been successfully completed? See pages 13 and 14 for details.
Please rotate both [AF GAIN] controls to their fully counter-clockwise positions, to avoid a loud blast of audio when
the transceiver turns on. See page 21 for details.
Rotate the [RF PWR] control fully counter-clockwise, to set minimum power at first. See page 20 for details.
If your AC mains power should suffer a significant fluctuation or interruption, we recommend that you go through a
complete power-up cycle, in order to ensure that all circuits are properly initialized. To do this, be sure the front panel
[POWER] switch is turned off, then set the rear-panel [POWER] switch to the “O” position. Now unplug the AC cable
from the rear panel of the transceiver, and wait ten seconds before proceeding with the start-up procedure described
below.
[POWER] switch is turned off, then set the rear-panel [POWER] switch to the “O” position. Now unplug the AC cable
from the rear panel of the transceiver, and wait ten seconds before proceeding with the start-up procedure described
below.
B
ASIC
O
PERATION
:
R
ECEIVING
ON
A
MATEUR
B
ANDS